> Rubber Made > TRANSMISSION Belts
Square Edge Construction
TBA Tranmission Belting is manufactured from
plies of duck woven in our own textile mill, impregnated with high grade
natural rubber compound and vulcanised into slab form. The belt is then slit
into the required widths providing the belt with square edges which are then
specially treated to protect them from the ingress of moisture. The belt
construction provides an excellent anchorage for belt fasteners and the
absence of joints enables this type of belt to run on either face.
These can be supplied in grades shown. As with most
endless belts provision should be made in the drive arrangment for taking up
any stretch which may occur in the belt during service.
Transmission belting of balanced construction
give maximum tensile strength without loss of flexibility.
Tenacious anchorage for all types of belt
Wide range of length, width, ply combinations
available to meet all requirements.
Excellent wear resistance due to the deep
penetration of specially compounded rubber into the weave of the fabric.
Having no stiff edges. The belt freely conforms
to the standard cambered pulley faces, without internal stress, thereby
increasing its tractive effort.
Heat and noisture resisting properties ensure
that TBA Transmission Beltings are ideally suited to use in tropical
climates and similar environments.
Quality assured – fabrics woven in our own
textile mill means that stringent quality control is exercised throughout
the manufacturing process.
To fit TBA Transmission Belting is to be safe
in the knowledge that the belting will perform efficiently and
satisfactorily even under the most arduous conditions.